Maintenance | HANGAR 10

Update detected

New discrepancy pending review

A new report has been detected. You can review it now.

Simulator—

Entry ID—

Source—

—

Review now

Notice update required

Corrective Actions changed

The current Notice to Instructor may be outdated. Please review Simulator Status and print a new Notice to Instructor.

A change was saved in Corrective Actions that affects the current Notice to Instructor.

Go to Simulator Status

Permanent deletion

Delete this corrective action?

The complete record, its notes and attached references will be permanently removed. This action cannot be undone.

Confirm action

Send discrepancy to Corrective Actions

If you continue, this discrepancy will be removed from Discrepancies and added to Corrective Actions so it can be reviewed and tracked by Engineering.

Please confirm that you want to move this discrepancy to Corrective Actions.

⚠

Known discrepancy

Confirm this issue is already covered

This issue has been previously reported and converted into a Corrective Action.

Before continuing, make sure this discrepancy does not contain any new finding or detail that is missing from the existing Corrective Action. Confirming will remove it from the open discrepancies list and keep it available in the discrepancy history.

Short description

Visible in Notice to Instructor

This is the description the instructor will read before starting the session.

Write this text from the instructor report, but only after the engineer has checked and filtered the issue. Keep it clear, brief and instructor-friendly: it should explain what the instructor needs to know before the session, without internal technical noise. Use Save Update to register a new current description and save the current instructor-facing information.

Engineer Internal Notes

Internal progress log

These notes are for engineer progress tracking only.

Use this area to record investigation progress, actions taken, pending parts or next steps for this corrective action. These notes are internal and are not shown in the Notice to Instructor.

Effect on training

Visible in Notice to Instructor

This text is shown together with the Short description.

Write any operational impact, restrictions, workarounds or instructor guidance that must be visible before the session. This information will appear in the Notice to Instructor together with the Short description.

Before saving

Check instructor-facing information

The Short description will be visible in the Notice to Instructor.

Before saving this update, please review the rest of the corrective action data, especially EFFECT ON TRAINING - NOTES FOR INSTRUCTORS. The current instructor-facing information will be saved together with this update.

🔧

Manual corrective action

Create a new finding

Use this when Engineering identifies a related issue that was not created from a Techlog entry. An Engineering Entry ID (ENGxxxx) will be created automatically. The Finding / issue description will also be used as the initial Short description.

Finding / issue description

This will create an active corrective action manually, with no Entry ID. After it is created, the engineer must fill in the corrective-action details and use Save Update so the record is complete.

Engineer access

Engineer access panel

If you do not receive the email within 1–2 minutes, please check your SPAM / Junk folder.

Aviso

Aviso